Change Buffering; Change Charsize - Lantronix MSS Reference Manual

Change Buffering

Defaults
See Also
2.10 Change Buffering
CHANGE SERVER BUFFERING
Specifies the size of the buffer (in bytes) to use for network connections. The default size should be
sufficient in most cases.
Restrictions
Parameters
Defaults

2.11 Change Charsize

CHANGE PORT PortList CHARSIZE
Sets the number of data bits per character for the specified serial port.
Restrictions
Errors
Parameters
In the absence of the Portlist parameter, the configuration will affect the MSS4's
Note:
current port only.
2-16
Remote
The MSS ignores the Break key and passes it to the remote host. Only
applicable if the session protocol supports Break events. Telnet supports Break
events, but Rlogin, raw TCP, and UDP do not.
None
Disables the Break key.
None
Change Local Switch, page 2-30.
buffersize
Requires privileged user status.
Server
MSS4 only.
buffersize
Specify a size from 128 to 4096 (bytes).
4096 bytes
7
8
Requires privileged user status.
Autobaud will only work when a port is set for 8 data bits with No parity or for
7 data bits with Even parity.
The MSS100 can only use charsize 8 when parity is set to None. The MSS4
and MSS-VIA can have any parity with charsize 8.
Port
MSS4 only. Specifies a particular port or group of ports.
Command Reference