Change Retransmit Limit; Change Rlogin - Lantronix MSS Reference Manual

Command Reference
Defaults

2.49 Change Retransmit Limit

'
CHANGE SERVER RETRANSMIT LIMIT
Specifies the number of retries attempted if a network message receives no acknowledgment. This number
may need to be increased on noisy or heavily-used networks. The rate at which retransmits are sent is
protocol and network dependent.
Restrictions
Parameters
Defaults

2.50 Change Rlogin

CHANGE SERVER RLOGIN
Controls the use of the Rlogin command. Incoming Rlogin connections are always permitted, but when
Rlogin is disabled, users may not log into remote hosts. To view the current status of Rlogin connections,
enter the Show Server command.
Restrictions
Parameters
Defaults
Enabled
number
Requires privileged user status.
Applies to TCP and LAT sessions only.
Server
MSS4 only.
number
Enter a value between 4 and 100.
10
DISABLED
ENABLED
Requires privileged user status.
Server
MSS4 only.
Disabled
Change Retransmit Limit
2-41