Cleaning The Interior - Xerox Phaser 6600 User Giude

•
For stubborn stains, apply a small amount of mild detergent to the cloth and gently wipe the stain
off.
CAUTION: Do not spray detergent directly on the printer. Liquid detergent could enter the printer
through a gap and cause problems. Never use cleaning agents other than water or mild
detergent.

Cleaning the Interior

Clean the interior of the printer regularly to prevent stains inside the printer that can deteriorate
printing quality. Clean the printer interior whenever you replace an imaging unit.
After clearing paper jams or replacing a toner cartridge, inspect the inside of the printer before
closing the printer covers.
•
Remove any remaining pieces of paper or debris. For details, see
148.
•
Remove any dust or stains with a dry, clean cloth.
WARNING: Never touch a labeled area on or near the heat roller in the fuser. You can get
burned. If a sheet of paper is wrapped around the heat roller, do not try to remove it immediately.
Switch off the printer immediately and wait 40 minutes for the fuser to cool. Try to remove the jam
after the printer has cooled.
Cleaning the Laser Lenses
If prints have voids or light streaks through one or more color, use the following instructions to clean
the laser lenses.
WARNING: If you accidentally get toner on your clothes, lightly dust them off as best as you can.
If some toner remains on your clothes, use cool water, not hot, to rinse off the toner. If toner gets
on your skin, wash it off with cool water and a mild soap. If you get toner in your eyes, wash it out
immediately with cool water and consult a doctor.
1. Turn off the printer.
CAUTION: If the optional Productivity Kit (HD) is not installed, ensure that the Ready LED is off
before you turn off the printer. The data in the memory is cleared when the printer is turned off.
2. Open the side door.
Maintenance
Clearing Paper Jams
Phaser 6600 Color Printer
User Guide
on page
117