Xerox Phaser 6600 User Giude page 41

1. Open the Printer Setup Utility.
2. At the Select Configuration screen, select Wi-Fi Configuration, then click Next.
3. At Select the current connection to printer screen, select the connection type the printer is
currently using.
4. Click Next.
5. From the Access Point list, select the SSID for the network to which you wish to connect.
6. If the desired network does not appear in the list, select Input the SSID directly, then enter the
network name in the SSID field.
7. Click Next.
8. In the Password field, enter the password for the selected network.
9. Click Next.
10. On the IP Address Settings screen, select the IP Mode to use for the connection:
•
Dual Stack allows the router to assign IPv4 and IPv6 IP addresses, as needed.
•
IPv4 directs the router to assign an appropriate IPv4 address only.
•
IPv6 directs the router to assign an appropriate IPv6 address only.
11. Select the type of method for assigning the IP address:
•
DHCP allows your DHCP server to assign an IP address to the printer. This option enables
Dynamic DNS Registration.
•
Auto IP allows the printer to assign an IP address to itself, in the absence of a
DHCP-capable router or access point.
•
Static IP enables the system administrator to assign an IP address to the printer.
a. If you selected Static IP, enter an IP Address that is in the range of the IP address of the
access point or router.
b. Enter the Network Mask, and Gateway Address.
c. If you need a specific IPv6 address, under IPv6 Settings, select Use Manual Address, then
enter the IP Address and Gateway Address.
Note: If the network and wireless router are IPv6 compatible, the router assigns an IPv6 address
as appropriate. Do not use Manual Address unless you are experienced assigning and using
IPv6 addresses.
12. Click Next.
13. At Confirm the Settings, select your Panel Language, then click Apply.
If any of the settings are incorrect, click the Back button to return to the previous screen.
14. To print a record of the IP settings, click Print Printer Settings.
15. Click Finish.
When the printer restarts, it uses the information from Printer Setup Utility to connect with the
wireless router.
16. If the Ethernet cable is connected to the printer, disconnect it.
17. Wait about two minutes, then print a Configuration Report to check the connection.
If the printer does not successfully connect with the wireless network, check your network
information and try again.
Installation and Setup
Phaser 6600 Color Printer
User Guide
41