Cleaning The Printer; Cleaning The Exterior; Cleaning The Interior; Cleaning The Led Lenses - Xerox VersaLink C600 User Manual

Maintenance
• Ensure that any parts removed during cleaning are replaced before you plug in the
printer.

Cleaning the Printer

Cleaning the Exterior

Clean the exterior of the printer once a month.
• Wipe the paper tray, output tray, control panel, and other parts with a damp, soft
cloth.
• After cleaning, wipe with a dry, soft cloth.
• For stubborn stains, apply a small amount of mild detergent to the cloth and gently
wipe the stain off.
Caution
Do not spray detergent directly on the printer. Liquid detergent could enter the printer
through a gap and cause problems. Never use cleaning agents other than water or mild
detergent.

Cleaning the Interior

Warning
Never touch a labeled area on or near the heat roller in the fuser. You can get burned.
If a sheet of paper is wrapped around the heat roller, do not try to remove it immediately.
Power off the printer immediately and wait 40 minutes for the fuser to cool. Try to
remove the paper jam after the printer has cooled.
To prevent stains inside the printer that can deteriorate print quality, clean the interior
of the printer regularly. Clean the printer interior whenever you replace a drum cartridge.
After clearing paper jams or replacing a toner cartridge, inspect inside the printer before
closing the printer covers and doors.
• Remove any remaining pieces of paper or debris.
• Remove any dust or stains with a clean, dry, lint-free cloth.

Cleaning the LED Lenses

If prints have voids or light streaks through one or more colors, use the following
instructions to clean the LED lenses.
7-2
® ®
Xerox VersaLink C600 Color Printer
User Guide