Configuring Windows
Setting the resolution of your B
Display
Note: In order to set the resolution of your B
Display you must be logged in using an account with
administrator privileges.
Accessing the Windows Display Control Panel
Open the "Windows Display Control Panel" by one of the
1.
methods below:
Start > Settings > Control Panel > Display
a)
Open the "Display Properties Control Panel" by right
b)
clicking in an empty area on the desktop, then select
Properties.
Windows Vista: Right click in an empty area on the
c)
desktop, select "Personalization", then click on "Display
Setting".
Click on the Settings tab (the Settings tab is not present in
2.
Vista).
Select the rectangle that represents the Barco display whose
3.
settings you wish to change.
Note: If you are using the VGA capabilities of your B
display controller, the resolution for the first display may be set
to a VGA resolution of "640 x 480" pixels with 16 colors and a
default refresh rate. If your B
VGA, the display may not be enabled yet. To enable the display,
check the "Extend my Windows desktop onto this monitor"
checkbox, but do NOT click the Apply button at this time.
If you installed your B
SingleView mode (default for Windows 2000) there will be one
MXRT controller is not running
ARCO
N
F
Display System drivers in
ARCO
IO
USION
Configuring Windows
N
F
ARCO
IO
USION
N
F
ARCO
IO
USION
ARCO
MXRT
63