Reinstalling Drivers - Barco LCD Display Getting Started Manual

When the Setup complete message appears, select Reboot
10.
System Now and click Finish.
After the system reboots, Windows may display either the
11.
Digital Signature Not Found message or The software you are
installing for this hardware has not passed Windows logo
testing.
Automated display configuration
Once the drivers, software and documentation have been installed
and your system has been rebooted, the Barco Monitor Plug and Play
Software should automatically detect your Barco displays and attach
them to the desktop with the correct resolution. If the Barco Monitor
Plug and Play Software fails to detect your Barco displays or fails to
attach them to the desktop correctly please refer to the section,
Setting the resolution of your Barco Display in the Configuring
Windows section of this manual.

Reinstalling drivers

You can install new drivers or reinstall existing drivers at any time by
using the Barco Set-up wizard on your B
Installation CD-ROM, see Installing the B
software, on page 50 of this manual.
Uninstalling the drivers and software
To uninstall the Barco drivers, software or documentation for your
Barco Nio Fusion Display Systems, please use the Windows Add/
Remove Programs or Uninstall utility. This can be found in the
Windows Control Panel. For Vista use Programs & Features.
Note: When uninstalling the Barco MXRT drivers, the dialog
box shown in figure 17 will appear, and select the driver listed.
Driver and Software Installation
N F Display System
ARCO IO USION
MXRT drivers and
ARCO
53