Barco LCD Display Getting Started Manual page 41

Connecting the signal cables
9
10
Figure 14: External DC power supply
After routing the cables (see further), startup the display by
7.
touching the touch key.
Note: When after startup you wish to change the screen
resolution, try to do so in the display control panel on the
computer. If you cannot select the desired resolution in the
control panel, you need to select the desired resolution in the
display OSD by means of the Preferred Input function in the
Settings menu. After changing this setting, you must reboot the
PC so that the graphic board adapts to the new setting. This
works only with plug-and-play graphic boards.
If you still cannot select the desired resolution, make sure the
Hide modes that this monitor cannot display option in the
control panel, Advanced Settings, Monitor tab is not checked
(see image below).
41