Barco LCD Display Getting Started Manual page 56

Driver and Software Installation
Note: When performing an MXRT driver upgrade, it is essential
to uninstall the previous installation before installing the new
driver. We also recommend that you perfrom the following steps
to completely remove the previously installed files:
Boot the system in safe mode.
a)
Run MXRT driver cleaner.bat by double clicking on it (this
b)
will either be installed as an icon on your desktop, or can
be found on the Barco Display System installation CD at:
drivers\2KXP\ATI). This will remove all the previous
installed MXRT driver files.
Reboot the system in regular mode and install the new
c)
driver.
56
Figure 18: Command line installation