Installation Procedure - Barco LCD Display Getting Started Manual

Display Controller Installation

Installation Procedure

The following instructions will take you step by step through the
installation of the display controller(s) for your B
Display System.
CAUTION – Wear a grounded, protective ESD strap when
handling or during installation of the display controller.
Electrostatic charges can damage the display controller.
If you are not going to use your old graphics card, uninstall the
1.
drivers and software for it if you have not already done so.
Turn off the computer, display(s), and other peripheral devices.
2.
Unplug the computer's power cord and disconnect all cables
3.
from the back of your computer.
Caution – Wait approximately 20 seconds after unplugging
the power cord before disconnecting a peripheral or
removing a component from the motherboard to avoid
possible damage to the motherboard.
Remove the computer cover.
4.
If necessary, consult your computer's manual for help in
removing the cover.
24
Figure 2: Examples of PCI slots
N F
ARCO IO USION