Barco LCD Display Getting Started Manual page 25

If necessary, unscrew or unfasten and remove any existing
5.
graphics card(s) from your computer.
Note: If you are using a motherboard containing an on-board
graphics solution and do not intend to use it as part of a
multiple-display setup, disable it either in the computer's
System Set-up utility (BIOS) or the Windows device manager.
Locate the appropriate slot and, if necessary, remove the metal
6.
back-plate cover(s).
Align the display controller(s) for your B
7.
System with the slot(s) and press it(them) in firmly until the
card(s) is(are) fully seated.
Note: The next step applies only to the MXRT 5100, MXRT
7100, and MXRT 7200.
Connect the power cable(s) to the 6-pin power connection(s) on
8.
the graphics card. Make sure the cables are not interfering with
anything inside the computer (for example, a cooling fan).
Display Controller Installation
N F
ARCO IO USION
Display
25