Connecting The Signal Cables - Barco LCD Display Getting Started Manual

Connecting the signal cables

To connect the signal cables to the display:
Unpack the display and put it on a solid flat surface.
1.
Make sure the computer is turned off.
2.
To get access to the connectors, remove the connector
3.
compartment cover (1).
To remove the cover, gently pull one side of the cover backward
to put the cover clips under stress. Then one by one, starting at
the side where you are pulling, release the 4 cover clips by
pressing with the other hand on top of the cover where the clips
are located (see drawing below).
To facilitate cable routing afterwards, remove the display stand
4.
neck cover (2). Therefore, first tilt the display panel in upright
position. Then lift and pull backward the neck cover.
Also to facilitate cable routing afterwards, open both cable duct
5.
covers (3).
Figure 12: Remove covers before connecting signal cables
Connecting the signal cables
1
2
3
39