Table of Contents
Advertisement
When the Setup complete message appears, select Reboot
10.
System Now and click Finish.
After the system reboots, Windows may display either the
11.
Digital Signature Not Found message or The software you are
installing for this hardware has not passed Windows logo
testing.
Automated display configuration
Once the drivers, software and documentation have been installed
and your system has been rebooted, the Barco Monitor Plug and Play
Software should automatically detect your Barco displays and attach
them to the desktop with the correct resolution. If the Barco Monitor
Plug and Play Software fails to detect your Barco displays or fails to
attach them to the desktop correctly please refer to the section,
Setting the resolution of your Barco Display in the Configuring
Windows section of this manual.
Reinstalling drivers
You can install new drivers or reinstall existing drivers at any time by
using the Barco Set-up wizard on your B
Installation CD-ROM, see Installing the B
software, on page 62 of this manual.
Uninstalling the drivers and software
To uninstall the Barco drivers, software or documentation for your
Barco Coronis Display Systems, please use the Windows Add/Remove
Programs or Uninstall utility. This can be found in the Windows Control
Panel. For Vista use Programs & Features.
Note: When uninstalling the Barco MXRT drivers, the dialog
box shown in figure 31 will appear, and select the driver listed.
Driver and Software Installation
C
Display System
ARCO
ORONIS
MXRT drivers and
ARCO
65
Advertisement
Table of Contents
