•
Multihost Enable
•
Multihost Delay
multihost operation.
Peer-to-Peer (Peer2Peer)
•
Rebroadcast Allowed (AP only)
municate through the AP to other enabled Peers (serial data only).
•
Ethernet Rebcast Allowed (AP only)
communicate through the AP to other enabled Peers (Ethernet data only).
•
Serial Rebcast Request (RM only)
other enabled Peers.
•
Ethernet Rebcast Request (RM only)
to other enabled Peers.
Communications Ports
COM1 Port Settings
•
— The default mode for
Startup Mode
ered up, but the startup mode may also be set to
payload data.
62
— Enables or disables multihost capability.
— Sets the desired delay time (in ms) for switching between hosts during
— Determines if the AP will allow enabled Peers to com-
— Determines if the AP will allow enabled Peers to
— Determines if the Remote is allowed to communicate to
— Determines if the Remote is allowed to communicate
SD Series Technical Manual
is
when the transceiver is first pow-
COM1
Console
if the port is to be used for passing
Data
MDS 05-4846A01, Rev. I