Adjusting The Picture Quality - JVC DR-M10 Instructions Manual

Filename [DR-M10SE_07Playback.fm]
DR-M10SE_01.book Page 45 Thursday, February 12, 2004 9:08 PM

Adjusting the picture quality

You can obtain optimal picture quality by selecting an
appropriate picture mode.
1
Access Play Set Up Menu.
Press ON SCREEN twice.
2
Select the menu item.
Press w e to select " ", then press ENTER.
The pop-up window appears under the selected item.
3
Select the desired option.
Press rt to select the desired option, then press ENTER.
NORMAL
: Normally select this option.
CINEMA
: Suitable for a movie disc, etc.
SHARP
: Clearer, sharper-edged picture when viewing
images with lots of flat, same-coloured surfaces
such as cartoons.
SOFT: Select this option when too much noise appears.
Page 45
Setting the progressive mode
You can obtain optimal picture quality by selecting whether the
content on the disc is processed by field (video source) or by
frame (film source).
1
Access Play Set Up Menu.
Press ON SCREEN twice.
2
Select the menu item.
Press w e to select " ", then press ENTER.
The pop-up window appears under the selected item.
3
Select the desired option.
Press rt to select the desired option, then press ENTER.
AUTO 1
: Used to play a disc containing both video
and film source materials. This system
recognizes the source type (video or film) of
the current disc according to the disc
information. Normally select this option.
AUTO 2
: Almost the same as the "AUTO 1", but the
processing of the scenes with movement is
different. Select "AUTO 1" or "AUTO 2" to
your preference.
FILM
: Suitable for playing back a progressive
scanned film source disc.
VIDEO: Suitable for playing back a video source disc.
The outlines on the played back pictures will
be soft.
NOTE:
When the progressive mode is set, be sure to set "L-1 OUTPUT"
to "COMPONENT". ( pg. 82, "L-1 Output and L-1 Input
Setting (L-1 OUTPUT and L-1 INPUT)") Progressive scan is
output only from COMPONENT VIDEO OUT connector.
Masterpage:Right-No-Heading
45
EN
February 12, 2004 5:09 pm