On-Disc Timer Programming - JVC DR-M10 Instructions Manual

Filename [DR-M10SE_08Recording.fm]
DR-M10SE_01.book Page 58 Thursday, February 12, 2004 9:08 PM
58
EN
On-Disc Timer
Programming
On-Disc Timer Programming is a function used with discs that
are especially intended for a specific programme. The disc is
then programmed for a programme you always watch every day
or every week. Since older programs are automatically
overwritten, a single DVD-RAM/RW (VR mode) disc can be used
without worrying about how much recording capacity remains.
( pg. 60, "How discs are overwritten")
You can programme each disc to timer-record as many as
8 programmes.
Before performing On-Disc Timer Programming:
Turn on the unit.
Turn on the TV and select the AV mode.
Slide the TV/CABLE/SAT/DVD switch to DVD.
Make sure that the unit's built-in clock is set properly.
ATTENTION:
On-Disc Timer Programming is possible only with the disc
for On-Disc Timer Programming.
If data is recorded on a disc for On-Disc Timer
Programming using a unit from another manufacturer, On-
Disc Timer Programming may no longer function properly.
TV TV AV
VIDEO
GHI
PQRS
CANCEL
PROG/CHECK
SHOW VIEW/ PROG/CHECK
VIDEO Plus +
TOP MENU
MENU
PREVIOUS
SLOW
REC
REC MODE LIVE CHECK
SET UP DISPLAY ON SCREEN
AUDIO SUBTITLE ANGLE
Page 58
CABLE/SAT
CABLE/SAT
TV DVD
TV DVD
STANDBY/ON
TV/CBL/SAT DVD
DVD1
TV%
ABC DEF
JKL MNO
TUV WXYZ PR
AUX MEMO/MARK
SAT# TIMER
NAVIGATION
rtwe
ENTER
ENTER
RETURN
NEXT
PLAY/SELECT SLOW
STOP/ CLEAR PAUSE
OPEN/
CLOSE
x
PROGRESSIVE
SCAN
TIMER RECORDING (cont.)
To make the disc for On-Disc Timer
Programming
A
Load a disc.
A Press x to open the disc tray.
B Place a recordable disc on the disc tray.
For details, refer to "Placing a Disc" (
C Press x to close the disc tray.
B
Access Programme Check screen.
Press PROG/CHECK.
C
Access the programme screen.
When On-Disc Timer Programming is made for the first
time on the disc
Press rt repeatedly to select "DISC TIMER PRGM",
then press ENTER.
When some programmes are recorded on the disc, a caution
message appears. In such a case, backup the programmes as
required, then format the disc before making On-Disc Timer
Programming. ( pg. 106, "Format a disc")
When On-Disc Timer Programming has already been
made on the disc
Press rt repeatedly to select "NEW TIMER
PROGRAMME", then press ENTER.
D
Enter the recording date.
Press rt repeatedly to set the desired date.
The current date appears on the TV screen. The date you enter
appears in its place.
E
Enter the recording start time.
Press w e to select "START", then press rt repeatedly
to set the desired start time.
Each press of rt advances/goes back the start time in 1-min.
increments.
To advance/go back the start time in 30-min. increments, press
and hold rt.
Masterpage:Left+
pg. 9).
February 12, 2004 5:15 pm