Preparation; Programmable Function Keys - Icom IC-F6062D Operating Manual

1

PREPARATION

■ Programmable function keys

The following functions can be assigned to [UP], [DOWN],
[P0], [P1], [P2], [P3] and [P4] programmable function keys.
Consult your Icom dealer or system operator for details con-
cerning your transceiver's programming.
If the programmable function names are bracketed in the fol-
lowing explanations, the specific key is used to activate the
function.
D For only BIIS 1200 operation
The following key function is required for BIIS 1200 operation.
BIIS BUTTON
➥ Push to enter the call code memory mode.
• Push [CH Up] or [CH Down] to select a desired Individual or
Group ID.
➥ While in the call code memory mode, push to enter the
message selection mode.
• Push [CH Up] or [CH Down] to select a desired status message
or Short Data Message (SDM).
➥ While in the message selection mode, push to return to the
stand-by mode.
➥ Hold down for 1 second to toggle between the memory
channel mode and the queue channel mode.
➥ While in the queue channel mode, push to toggle between
the queue channel mode and the received message
mode.
"" appears above the key assigned to the BIIS Button
function, when it is activated.
1
D For only dPMR operation
The following key functions are required for dPMR operation.
dPMR BUTTON
➥ Push to enter the ID selection mode.
• Push [CH Up] or [CH Down] to select a desired Individual or
Talkgroup ID.
➥ While in the ID selection mode, push to enter the application
selection mode.
• Push [CH Up] or [CH Down] to select a desired application from
"STATUS," "MESSAGE," "STAT POL," "LISTENING," "STUN,"
"KILL," "REVIVE" and "CALL LOG."
➥ If you select
"STATUS" or "MESSAGE"
tion mode, push to enter the message selection mode.
• Push [CH Up] or [CH Down] to select a desired message.
➥ While in the application selection mode, push to return to
the stand-by mode.
CLEAR
After communication is finished, push this key to send a 'Dis-
connect' signal to terminate the connection.
Depending on the pre-programmed settings, the Priority A
channel is automatically selected after a 'Disconnect' sig-
nal terminates a connection.
in the application selec-