Icom IC-F6062D Operating Manual page 18

3
dPMR OPERATION
D Receiving an SDM
q When an SDM is received:
• Rings sound.
• " " appears.
• The calling station's ID (or name) and the SDM are displayed.
The received
SDM
NOTE: When the SDM includes more than 12 charac-
ters, it automatically scrolls.
• Push [Status Up] or [Status Down] to stop scrolling, or
manually scroll the message.
R E T U R N
I D
w Push [Clear] to return to the stand-by mode.
15
M e s s a g e 1
I D 0 0 0 0 0 0 1
Calling station's ID
T O O F F I C E
0 0 0 0 0 0 1
Scrolls
D Receiving a Stun, Kill or Revive call
If an Individual call with a Stun or Kill command is received
from a specified station, the transceiver will display "SORRY,"
and becomes unusable.
NOTE: If the transceiver receives a Stun, Kill, or Revive
Appears
command from a station other than the specified ones, the
call will be ignored, and the transceiver will not be stunned,
killed, or revived.
➥ When a Stun command is received, the transceiver is
disabled*
inputting the password*
ceiver again.
*
1 Depending on the pre-programmed settings, receiving a Stun
command inhibits only transmission, but the transceiver still
can receive.
*
2 Depending on the pre-programmed settings.
➥ When a Kill command is received, the transceiver is disa-
bled. In that case, re-programming the transceiver is nec-
essary to operate the transceiver again.
D Receiving a Status Polling call
If a Status Polling call is received, the transceiver will auto-
matically transmit its current status.
. In that case, receiving a Revive command or
1
is necessary to operate the trans-
2