Icom IC-F6062D Operating Manual page 23

D Transmitting a status message
You can send a pre-programmed status message to an indi-
vidual station or to group stations.
There are 32 status messages that can be sent.
q Push [dPMR Button] to enter the ID selection mode.
• The pre-programmed ID is displayed.
w Push [CH Up] or [CH Down] to select a desired Individual
ID or Talkgroup ID.
e Push [dPMR Button] again to enter the application selec-
tion mode.
• "STATUS" is displayed.
r Push [dPMR Button] again to enter the status message
selection mode.
• The pre-programmed status message is displayed.
t Push [CH Up] or [CH Down] to select a desired status
message.
S T A T U S
T X S t a t u s
A status message is displayed.
y Push [Call] to transmit the status message to the selected
u After a specified time period, the transceiver will return to
0 1
0 1
dPMR OPERATION
station or talkgroup.
• "WAIT" is displayed while transmitting.
• "OK" is displayed when an acknowledgement is received.
• "FAILED" is displayed when no acknowledgment is received.
the stand-by mode.
3
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
20