Transmitting A Call - Icom IC-F6062D Operating Manual

2
BIIS 1200 OPERATION

■ Transmitting a call

D General
• Editing an ID
If the transceiver has a key assigned to the TX Code Enter
function, you can edit an ID within the allowable digits.
q Push [TX Code Enter] to enter the ID edit mode.
• The digit to be edited blinks.
w Push [TX Code Enter] to select a desired digit to be ed-
ited.
e Push [CH UP] or [CH DOWN] to select a desired number.
r Push [TX Code Enter] to set. The digit to the right will au-
tomatically blink.
t Repeat step e and r to input all allowable digits.
y After editing, push [TX Code Enter] to store the setting.
• The transceiver returns to the standby mode.
NOTE: To overwrite the original ID, set the 'Update' item to
"Enable" using the CS-F3160/F5060 (dPMR)
. Otherwise, changing the channel or turning
software
OFF the transceiver discards the new ID, and returns the
original one. Ask your dealer for details.
7
D Transmitting an Individual or Group call
NOTE: If you want to make a call to the pre-programmed
ID, skip step q and w, then directly go to step e.
q Push [BIIS Button] to enter the call code memory mode.
• The pre-programmed ID is displayed.
• " " appears.
w Push [CH Up] or [CH Down] to select a desired Individual
ID or Group ID.
e Push [Call] to make a call.
• "WAIT" appears while transmitting.
• "CONNECT" is displayed when an acknowledgement is received.
NOTE: If no acknowledgement is received, the trans-
cloning
ceiver automatically repeats the call 3 times (default).
However, when no acknowledgement is received after
each of the calls, an error beep sounds and "FAILED"
is displayed. In that case, the transceiver automatically
returns to the stand-by mode.
r After "CONNECT" is displayed, hold down [PTT] and
speak into the microphone at your normal voice level. Re-
lease [PTT] to receive.
t After the communication is finished, push [Moni (Audi)] to
send a 'Clear down' signal to terminate the connection.
Appears
1 2 3 4