Cloning - Icom IC-T3H Instruction Manual

Cloning allows you to quickly and easily transfer the programmed
contents from one transceiver to another transceiver.
D Transceiver-to-transceiver cloning
q
Connect the OPC-474
master and sub-transceivers.
• The master transceiver is used to send data to the sub-transceiver.
w
While pushing [A•
mode (master transceiver only— power ON only for sub-trans-
ceiver).
• "CLONE" appears and the transceivers enter the clone standby
condition.
e
Push [PTT] on the master transceiver.
• "CL" appears in the master transceiver's display and two digit num-
bers show that data is being transferred to the sub-transceiver.
N
• "CL I " appears automatically in the sub-transceiver's display and
two digit numbers show that data is being received from the master
transceiver.
r
When cloning is finished, turn power OFF, then ON again to exit
cloning mode.
NOTE: DO NOT push the [PTT] on the sub-transceiver during
cloning. This will cause a cloning error.
CLONING CABLE
] + [Y], turn power ON to enter cloning
FUNC

CLONING

AT
to the [SP] jack of the
12
POWER ON
54