Kodak SR series User Manual page 67

SCSI Download Application Note
4. Power up the Motion Corder. Check the SCSI ID of the unit in the
menu under System, External I/O. The default is ID 5. If ID 5 con-
flicts with another SCSI device attached to the bus change the ID to
any other unused SCSI ID and return to LIVE mode. Power off the
unit to save the change, then power up once again.
5. Check the Frame Rate. Be sure that it is set less than 3000FPS. If the
Frame Rate is 3000FPS or higher, the message " —CAUTION— The
Overheat-Protection is in Operation" will be displayed. Reduce the
Frame Rate if required before going to Step 6.
6. Power up the PC. If the Adaptec AHA-1542 or AHA-2940 adapter is
used and the SCSISelect utility is enabled, press Ctrl + A to start the
utility when prompted during boot up. Press Enter to get to the utility
Options Menu. Select "Configure/View Host Adapter Settings". Be
sure that "Host Adapter SCSI Termination" is set to Automatic. Next,
go to "Advanced Configuration Options". Be sure that " 'Plug and
Play' SCAM Support" is Disabled. If the AHA-2940 adapter is used,
enter the "SCSI Device Configuration" menu and set "Enable Wide
Negotiation" to NO (OFF) for the Motion Corder's SCSI ID#. Save
the changes and exit the utility.
7. Place the disk that contains the Readcam.exe Digital Download pro-
gram in the floppy drive. If available on the disk, run the Setup.exe
program to install the Download program. If Setup.exe is not on the
disk, use Windows NT Explorer to create a new directory. Then, copy
the Readcam.exe file into the new directory.
8. If not done previously, install the Adaptec EZ-SCSI 4.0 software.
9. The system is now configured for Digital Download.
A.18