Kodak SR series User Manual page 30

Viewing a Recording
USING THE RETICLE
Open the Playback menu and highlight RETICLE. Press the MENU/ENTER
button to open the RETICLE sub menu. There are three options:
- DISPLAY PARAMETERS -
4. RETICLE
è
Use the s and t arrows to move up and down the options. Press the MENU/
ENTER button to select the highlighted option. When the reticle is on, the reticle
X and Y coordinates appear in the lower right quadrant of the picture and a
reticle overlays the picture.
When you return to the display after turning the reticle ON you will be able to
adjust the X reticle position. Press MENU/ENTER to step to the Y reticle
position adjust. Press the MENU/ENTER button once more to enter the single
step mode.
If you are in play and the reticle is already on, press STOP/ESC to enter single
step mode. Find the frame you want to measure and then press MENU/ENTER
button, the word STEP in the data display will change to < X >, then use the s
and t arrows to change the reticle X coordinate. Press the MENU/ENTER
button again and then use the s and t arrows to change the reticle Y coordinate.
Press the MENU/ENTER button once more to return to the single step mode.
Once you have entered the single step mode the MENU/ENTER button will cycle
through X coordinate adjust, Y coordinate adjust, and single step. You can exit
the cycle at any point by pressing the STOP/ESC button or the
button to resume playback.
ON
ON
OFF
ESC
(Direction)
3.11