Processor Front Panel - Kodak SR series User Manual

Processor Front Panel

TOP SECTION
The front panel of the Motion
Corder is broken into two sections,
the top panel carries connections
for the camera and the viewfinder.
MCDL
A nine pin D subminiature connec-
tor that accepts the cable connected
to the Multi Channel Data Link
(MCDL). The User can supply
analog and digital data to be
recorded along with the images
from the Imager.
SCSI
This is the Small Computer System
Interface (SCSI) input connector.
This connector accepts SCSI
protocol commands from a com-
puter and provides a data path for
digital video downloads.
LOOP THROUGH
A SCSI connection to the next
device on the SCSI bus, or if the Motion Corder Processor is the last device on
the SCSI bus, a termination plug should be inserted in this connector.
BOTTOM SECTION
The main power switch, a switch for the lights, a 12 volt AC power connector for
the lights and a power on indicator are located on the lower panel.
CAUTION
The 12 VAC for the lights must have at least a 75 watt but no more than 150 watt
load for proper operation. If you are using a 220 Volt AC source, you must turn
the lights ON and OFF with the light switch next to the main power switch.
If the lights do not come on, make sure that both lights are switched ON at the
lamp head and then turn the power to the lights OFF and then back ON using the
main light switch next to the power switch. The lights will not illuminate if you
turn the lamps OFF and then try to turn them back ON again using the switches at
each lamp head.
CAMERA
DC OUT 7.5 V
VIDEO OUT
MCDL
SCSI
LOOP THROUGH
2.5