Kodak SR series User Manual page 36

Using the System Menu
ADJUSTING COLOR TEMPERATURE (CONTINUED)
The three numbers to the right of EDIT USER1 represent the video amplitude of
red, green, and blue. To change the red value highlight RED UP, or RED DOWN on
the menu, and then press the MENU/ENTER button to change its value one count.
Each press of the MENU/ENTER button changes the red amplitude one count.
The color channel values range from zero to sixty three. Leave green set to
sixteen and adjust the red and blue channels to color balance the Motion Corder.
The Motion Color is color balanced when gray objects appear gray, without any
color tinting, on a color video monitor.
To change the overall sensitivity of the Motion Corder change the green channel
value. Increasing green from 16 to 32 will make the Camera one f-stop more
sensitive. When you increase the red and blue values to color balance the Motion
Corder you will have greater sensitivity, but at the cost of increased noise in the
picture.
Return all three channels to the default value of sixteen with CLEAR.
ENABLING OVERHEAT PROTECTION
Open the Sytem menu and highlight OTHERS. Press the MENU/ENTER button
to open the OTHERS menu that appears as follows:
- SYSTEM PARAMETERS -
7. OTHERS
è
Use the s and t arrows to move up and down the options. Press the MENU/
ENTER button to select the highlighted option. It is possible for the Imager to
overheat when it is operated at 3,000, 5,000, and 10,000 frames per second. A
count down timer appears in the viewfinder imager when overheat prevent is in
effect. The count represents the number of seconds remaining before the Imager
is switched to 250 fps. The counter decrements once each second. When the
count reaches 0000 the frame rate is set to 250 fps.
CAUTION
You can turn overheat prevent off but this may result in damage to the Imager.
OVEHEAT PREVENT
SETUP LEVEL 7.5
- -RESERVED- -
- -RESERVED- -
- -RESERVED- -
ESC
[color models only]
3.17