Processor - Kodak SR series User Manual

Processor

REAR PANEL
The rear panel of the Motion Corder Processor has a control panel, a connector
panel and the AC power input connector with fuses.
CONTROL PANEL
The control panel has eight
membrane push buttons that
control setup, recording and
playback.
CONNECTOR PANEL
The connector panel has a
power on indicator, different
types of trigger inputs, sync
inputs, and a video output.
POWER INPUT
The AC power input is a
standard IEC/CEE plug
connector. The KODAK
Motion Corder can be ordered
with input power of either 110
volts, 60 Hertz AC or 220
volts, 50 Hertz AC. The input
power line is fused at 6.3 Amperes. The power switch on the front panel of the
Processor turns the Motion Corder on and off.
CAUTION
The KODAK Motion Corder Analyzer must be turned off before connecting or
disconnecting the AC power cord.
2.2
REC
TRIGGER MODE STOP
READY
ESC
EXT IN Y/C
TRIGGER IN TRIGGER SW IN SYNC OUT
RS232C
MENU
ENTER
POWER
VIDEO OUT