Kodak SR series User Manual page 13

Processor Rear Panel Connectors
EXT IN
A BNC type connector that
accepts a synchronizing signal
input from an optional signal
generator, allowing the user to
control the start of each frame.
Y/C
A multipin connector that
carries the luminance and
chroma components of the
output video as separate signals.
Connect to video monitors and
VCRs equipped with the same
style video input connectors for
higher quality video.
POWER
An indicator light that illuminates when power is turned at the front panel of the
Processor.
TRIGGER IN
A BNC type connector that accepts a TTL compatible signal to start or end a
recording depending upon the record mode selected. The input is connected to an
opto-isolator requiring roughly 10 milliamps drive current from a 5 volt source.
TRIGGER SW IN
A switch closure between the shield and the center conductor of this BNC type
connector will start or stop a recording depending upon the record mode selected.
SYNC OUT
A BNC type connector that provides a TTL compatible synchronizing signal at
the beginning of each picture frame.
VIDEO OUT
BNC type connector that carries the video output signal from the Motion Corder.
This output is designed to drive a 75 Ohm coaxial cable that can be connected to
a video monitor, VCR or hard copy video printer.
RS232C
A twenty five pin D subminiature connector for a serial data communication port.
This port is for connection to a remote computer and conforms to the RS232C
specification.
EXT IN Y/C
TRIGGER IN TRIGGER SW IN
RS232C
POWER
SYNC OUT VIDEO OUT
2.3