7—Mixer Views
Multi-Channel Strip Views
The multi-channel strip views show a detailed view of the set of 16 channels currently
selected with the FADER buttons. To view the desired set of multi-channel strips, click
the desired FADER button, described below.
There are five onscreen multi-channel strip view FADER buttons, one more than on the
VS-2480's top panel. The fifth button is the V.FDR button—on the VS-2480, the V.FADER
channels are selected by holding down SHIFT and pressing TR 17-24•FX RTN.
The Multi-Channel View MASTER Strip
All of the multi-channel views share a common MASTER strip. This
section describes what you'll find in this strip.
1. FADER/V.FDR buttons
These buttons perform the same job as the VS-2480's
top-panel FADER buttons and the V.FADER button. To
view a set of 16 channel strips, click the corresponding
button. To view the V.FADERS, click V.FDR.
2. MON (MONITOR) Balance Knob
Drag the MON (for "MONITOR") balance knob up or down to shift the
MONITOR bus output leftward or rightward, respectively.
3. MON (MONITOR) Level Knob (Info Only)
The MON (for "MONITOR") knob shows the level of the MONITOR bus.
This level can be adjusted only using the VS-2480's MONITOR knob.
4. MASTER Bus Effect Insert
To insert an effect processor on the MASTER bus, click its number—the
MASTER EFFECT INSERT screen appears.
5. AUTOMIX STATUS Button
Click the AUTOMIX STATUS button to set the MASTER fader's
Automix status when Automix is turned on.
6. MASTER Bus Balance Knob
Drag the MASTER bus balance knob up or down to shift the MASTER bus output right or
left, respectively.
70
www.RolandUS.com
Roland VS-2480 Owner's Manual, Version Two Addendum
137
219
327
1.
2.
3.
4.
5.
6.
7.
8.