Multi-Channel View Input Channels - Roland VS-2480 Owner's Manual Addendum

7. MASTER Bus Fader
Drag the MASTER bus fader up or down to set the level of the MASTER
bus—this is the same thing as moving the physical MASTER fader on
the VS-2480. The current MASTER bus level is shown beneath the fader.
8. DITHER
To activate output dithering, click and hold the DITHER button and
select the desired dithering bit depth.

Multi-Channel View Input Channels

1. Input Signal Selector
Click the input signal selector to select the desired
input signal for the channel. Odd-numbered
inputs can be assigned to odd-numbered input
channels, and even-numbered inputs to even-
numbered input channels.
2. PHASE (INV) Button
Click the PHASE button so it lights to reverse the
phase polarity of the input channel's signal.
3. ATT Knob
The ATT knob sets the level of the signal coming
into the channel as shown to the left of the knob.
4. DYNAMICS (DYN) Switch and Overview
Turn on the channel's dynamics processor by clicking the DYN
switch so it lights. The selected type of dynamics processor is shown
beneath the switch along with the current dynamics curve.
5. EQ Switch and Overview
Turn on the channel's EQ by clicking the EQ switch so that it lights.
The current EQ curve appears below the switch.
6. AUX Send Sliders
Set the amount of the channel's signal sent to an Aux bus by adjusting
the corresponding AUX send slider. With linked Aux busses, a panning
handle replaces the even-numbered Aux bus's slider (Page 67).
Roland VS-2480 Owner's Manual, Version Two Addendum
7—Mixer Views
166
6.
8.
10.
154
153
www.RolandUS.com
142
366
1.
2.
3.
4.
5.
7.
9.
11.
12.
13.
14.
153
153
152
71