Multi-Channel View Aux And Direct Bus Channels - Roland VS-2480 Owner's Manual Addendum

Multi-Channel View Aux and Direct Bus Channels

Direct Bus Parameters
1. Source
Click Source and choose the signal you want to assign to the Direct
bus.
2. Pre/Post Switch
This sets the Direct bus to receive a channel's signal before or after the channel fader.
3. AUTOMIX STATUS (A) Button
When Automix is on, repeatedly click this button to set the Direct bus' Automix status.
4. Final Level Knob
Drag this knob to set the final level of the Direct bus.
Aux Bus Parameters
1. PRE/POST Switch
Click the PRE/PST switch to configure the Aux bus to accept
channel signals from before or after the channel faders.
2. AUTOMIX STATUS (A) Button
When Automix is on, repeatedly click the AUTOMIX STATUS
button to set the Aux bus's Automix status.
3. Linked Aux Bus Balance
When an odd/even pair of aux busses is linked, this knob becomes active (see below)
and allows you to set the left/right balance of the pair of busses.
4. Aux Bus Master Level
Drag this knob to set the master level of the Aux bus.
5. LINK
To link or un-link odd/even Aux bus pairs, click the LINK button so it
lights. When two Aux busses are linked, their appearance changes
onscreen to reflect their combined operation.
In the VGA, linked Aux busses change the way in which their Aux send
sliders are shown in the various channel views and the track controls, as
explained on Page 67.
Roland VS-2480 Owner's Manual, Version Two Addendum
7—Mixer Views
2.
3.
1.
2.
www.RolandUS.com
1.
4.
3.
4.
5.
73