3—Version Two VGA Overview
The Main Display and the Info Display
Whenever an external VGA monitor is connected, the VS-2480 provides a main display
and an Info Display. The:
•
•
You can select the VGA display or the LCD display as the main display, but not both at
the same time. When you select the main display—by setting the OPERATION
TARGET parameter—the other display is automatically designated as the Info Display.
Setting the Operation Target
The VS-2480 displays the currently selected operation target when it powers up.
•
•
Manually Setting the OPERATION TARGET Parameter
1. Press UTILITY.
2. If "SYSTEM" isn't visible above F1, press PAGE until it is.
3. Press F1 (SYSTEM).
4. Press F2 (Param2) and locate the OPERATION TARGET parameter.
5. Set OPERATION TARGET to VGA or LCD. On the main display, the VS-2480 asks:
6. Press ENTER/YES to proceed, or EXIT/NO to cancel the change.
About the Main Display
The LCD as Main Display
When the LCD is designated as the main display, it behaves as described in the VS-2480
Owner's Manual, starting on Page 70.
Roland VS-2480 Owner's Manual, Version Two Addendum
main display—is where you work. You can interact with the main display using your
mouse, keyboard and the VS-2480's top-panel controls. All messages appear here.
Info Display—is a non-interactive screen that provides helpful supplemental
information. Page 21 describes how to determine the contents of the Info Display.
You can toggle between the two OPERATION TARGET settings—VGA or LCD—by
holding down SHIFT and pressing the UTILITY button. Each time you reset the
OPERATION TARGET, the previously selected main display confirms the change.
The internal LCD shows:
You can manually set the OPERATION TARGET parameter as described below.
The external VGA shows:
or
www.RolandUS.com
19