The Playlist's Measure Bar - Roland VS-2480 Owner's Manual Addendum

5—VGA Main Display Home Screen
When you change an Aux bus's pre/post setting, you're setting the pre/post
configuration of the Aux bus for any channel that's using it, as described on Owner's
Manual Page 153.
The color of each Aux bus's slider provides helpful information at a glance. When a
slider's:
•
•
•
When odd/even Aux busses are linked, the even-numbered bus's slider is replaced by a
panning handle, as described on Page 67.
22. Status Toggles
Beneath the track control areas are five status toggle buttons. You can click each button
to toggle the setting of the entire column of buttons directly above it.
Click this status toggle:
MUTE
SOLO
AUTOMIX STATUS
PHRASE SEQ
STATUS
TRACK STATUS

The Playlist's Measure Bar

Just above the playlist is a gray strip called the "measure bar" (Page 38). The lines in the
bar show the project measures as defined by the project tempo map (Owner's Manual
Page 312). The time bar also contains markers, CD track markers, edit point flags,
punch points and loop points.
44 www.RolandUS.com
blue—the send is turned on and the bus is set to Post.
red—the send is turned on and the bus is set to Pre.
gray—the send is turned off.
MUTE status toggle
SOLO status toggle
To:
un-mute all currently muted tracks.
un-solo all currently soloed tracks.
set the status of all Automix tracks to the same value.
set the phrase sequencer status of all phrase sequencer tracks
to the same value.
set the TRACK STATUS of all tracks to the same value.
Marker CD Track Marker
Auto Punch Points
Punch in Punch out
When Auto Punch is on, a red bar
connects the punch points.
Roland VS-2480 Owner's Manual, Version Two Addendum
TRACK STATUS toggle
PHRASE SEQ STATUS toggle
AUTOMIX STATUS
IN OUT
Loop start
When looping is on, a blue loop box
connects the start and end points.
Edit Points
FROM TO
Loop Points
Loop end