Input Mixer/Master Block View; Input Channel Strips - Roland VS-2480 Owner's Manual Addendum

Input Mixer/Master Block View

Select INPUT MIXER/MASTER BLOCK from the MIXER menu to view all of the
VS-2480's 24 input channel strips and MASTER BLOCK settings at once on the VGA.

Input Channel Strips

1. DYNAMICS (DYN) On/Off
Click this button to turn the channel's dynamics processor on—so the
button's lit—or off. See Page 57.
2. EQ On/Off
To turn the channel's EQ on or off, click this button. When it's lit, the
EQ's on. See Page 57.
3. AUX Send Sliders
Set the amount of the channel's signal sent to an Aux bus by adjusting
the corresponding AUX send slider. With linked Aux busses, a panning
handle replaces the even-numbered Aux bus's slider (Page 67).
4. MUTE (M) Button
To mute the channel, click this button so it's lit. To un-mute the channel,
click the button again.
5. SOLO (S) Button
To solo the channel, click the SOLO button to light it. To un-solo the
channel, click the button again.
6. AUTOMIX STATUS (A) Button
When Automix is turned on, repeatedly click the AUTOMIX STATUS
button to set the channel's Automix status.
Roland VS-2480 Owner's Manual, Version Two Addendum
FADER
button
indicator
Input Mixer
7—Mixer Views
Master Block
4.
6.
www.RolandUS.com
1.
2.
3.
5.
7.
8.
9.
152
142
142
327
65