Fujitsu F9600 User Manual page 31

5. Verify the autodial number if
you have a display Digital
Telephone.
6. Press the program mode
button to save the number
and exit the Program mode.
NOTES
1. When programming an outside number, the outside line code
must be programmed first.
2. Pressing TRANSFER displays "-" and inserts a pause.
3. Pressing FLASH displays "/" and inserts a flash. This must be
entered before any other digits.
4. Pressing MIC-OFF displays "X" and inserts a mask. Any digits
entered between the Xs display as X when that autodial button is
used so that the programmed number does not display. The
programmed number will redisplay after an outside line has been
accessed.
5. The programmed number can consist of any digits including #, *,
hookflash, and pauses for a set time, dial tone detection, or
manually-dialed digits.
To use the Autodial feature:
Action
1. Select the upper or lower
position by pressing the ATL
button.
2. Lift handset or press
SPEAKER.
3. Press the autodial button.
NOTES
1. Wait until the first autodial lamp goes out before pressing another
autodial button when you place calls using successive autodial
buttons.
2. After a number has been dialed, it is possible to dial additional
numbers by pressing another preprogrammed autodial button.
When the autodial button is pressed, the lamp will flash briefly.
Autodial (Cont'd)
The program mode lamp
goes out.
Results
The ATL lamp lights.
You can hear dial tone.
The autodial (ATD)
lamp flashes.
21