System Description - Omron SYSMAC C200H-IDS01-V1 Operation Manual

System Description

Section Overview
1-1

System Description

C200H ID Sensor Systems
Hand-held Program-
ming Console*
C200H-PRO27-E
Read/Write
Head V600
series
Data Carrier
V600 series
2
This manual covers the operation of two ID Sensor models, the C200H-
IDS01-V1 Electromagnetic Induction ID Sensor Unit and the C200H-IDS21
Microwave ID Sensor Unit. The main difference between the Units is the dis-
tance at which the ID Sensor can read data from or write data to the Data Car-
rier. The Microwave ID Sensor Unit allows the Data Carrier to be placed
farther from the Unit.
This section describes the components, installation, and configuration of both
models.
The ID Sensor system is a versatile noncontact identification system compris-
ing an ID Sensor Unit, a single Read/Write (R/W) Head or Antenna, and a
Data Carrier.
The ID Sensor mounts to a C200H Programmable Controller (PC); the Data
Carrier mounts to a moving workpiece or workpiece carrier. The R/W Head or
Antenna, connected to the ID Sensor Unit by a cable, must be positioned
within communication range of the travel path of the Data Carrier. Responding
to commands from the user program in the CPU of the PC, the ID Sensor
reads data from or writes data to the Data Carrier through the R/W Head or
Antenna. The operation of the ID Sensor can be monitored and tested with
the Handheld Programming Console; messages appear on the display of the
Console.
The following diagram illustrates two ID Sensor systems, one using a C200H-
IDS01-V1 ID Sensor and one using a C200H-IDS21 ID Sensor.
Electromagnetic Induction ID
Sensor Unit (C200H-IDS01-V1)
Connecting Cable
Connecting Cable
30.5 m max. when using the V600-H07
50.5 m max. when using the V600-H11/H51/H52
R/W Antenna
V620 series
Hand-held Program-
ming Console*
C200H-PRO27-E
Data Carrier
V620 series
Section 1-1
Microwave ID Sensor
Unit (C200H-IDS21)
Connecting Cable
10 m max.