Intended Audience; General Precautions; Safety Precautions - Omron SYSMAC C200H-IDS01-V1 Operation Manual

Intended Audience

1

Intended Audience

2

General Precautions

!WARNING
3

Safety Precautions

!WARNING
!WARNING
!WARNING
!WARNING
!WARNING
xii
This manual is intended for the following personnel, who must also have
knowledge of electrical systems (an electrical engineer or the equivalent).
• Personnel in charge of installing control devices.
• Personnel in charge of designing control systems.
• Personnel in charge of managing control systems and facilities.
The user must operate the product according to the performance specifica-
tions described in the operation manuals.
Before using the product under conditions which are not described in the
manual or applying the product to nuclear control systems, railroad systems,
aviation systems, vehicles, combustion systems, medical equipment, amuse-
ment machines, safety equipment, and other systems, machines, and equip-
ment that may have a serious influence on lives and property if used
improperly, consult your OMRON representative.
Make sure that the ratings and performance characteristics of the product are
sufficient for the systems, machines, and equipment, and be sure to provide
the systems, machines, and equipment with double safety mechanisms.
This manual provides information for operating the ID Sensor system. Be sure
to read this manual before attempting to use the ID Sensor systems and keep
this manual close at hand for reference during operation.
Since the V620 ID Sensor system uses microwaves of 2,450 MHz, permission
is required from the local electrical communications regulatory board before
installing the system.
It is extremely important that ID Sensor systems be used for the specified pur-
pose and under the specified conditions, especially in applications that can
directly or indirectly affect human life. You must consult with your OMRON
representative before applying ID Sensor systems to the above-mentioned
applications.
Do not attempt to disassemble, repair, or modify any Units. Any attempt to do
so may result in malfunction, fire, or electric shock.
Do not attempt to take any Unit apart while the power is being supplied. Doing
so may result in electric shock.
Do not touch any of the terminals or terminal blocks while the power is being
supplied. Doing so may result in electric shock.
Do not throw the Data Carrier into fire or heat the Data Carrier to a tempera-
ture exceeding 100 ° C. Doing so may cause ignition or burning of the built-in
lithium battery.
Do not short the battery terminals or charge, disassemble, heat, or incinerate
the battery. Doing any of these may result in leakage, rupture, heat genera-
tion, or ignition of the battery.
1