Omron SYSMAC C200H-IDS01-V1 Operation Manual page 76

Monitoring
Data Setting
DATA
5
A
After the address to be accessed has been set, input and set the data. Refer
to the following figure.
HEAD 1 PAGE 1
STadrs1F data _
HEAD 1 PAGE 1
STadrs1F data 5_
HEAD 1 PAGE
STadrs1F data 5A
After the lower digit has been entered, the data is automatically set; it is not
necessary to press the SET key.
If you have entered the wrong data, or you want to change the data, press the
DATA key and repeat the procedure.
If the Read command is subsequently used to read data to the same data
area, the set data will be changed to the value read by the Read command.
Press the DATA key to begin entering
and setting data.
First, enter the value of the leftmost
digit (0 through F). In this example,
the higher digit is 5.
Next, enter the value of the rightmost
digit (0 through F). In this example,
the lower digit is A.
Section 3-2
61