Step Write (Write 1) - Omron SYSMAC C200H-IDS01-V1 Operation Manual

Monitoring
3-2-6

Step Write (WRITE 1)

start
address/
data setting
WRITE
Normal
completion
When an
error occurs
RESET
This operation writes 1 byte of specified data to a specified address in the
Data Carrier. Refer to the following figure.
Before performing this operation, select the address and the data you want to
write. Refer to 3-2-4 Address/Data Setting for details.
HEAD 1 PAGE 1
STadrs1F data 83
start address
(write address)
HEAD 1 PAGE 1
1
SWadrs1F data
Indicates that Step Write will be exe-
cuted.
HEAD 1 PAGE 1
SWadrs1F data 83
HEAD 1 PAGE 1
SWadrs1F NO DC E
HEAD 1 PAGE 1
SWadrs1F error 72
HEAD 1 PAGE 1
STadrs1F data 83
Data to
be written
Data to be written
Error message
or
Error code number
Set the data to be written and
the address in the Data Car-
rier the data is to be written to.
Press the WRITE 1 key to
write the data to the start
address and begin the Step
Write operation.
If the data is written correctly,
it is displayed as shown in
the example.
If an error occurs during the
operation, the buzzer sounds
for 2 seconds, and an error
message is displayed (refer to
3-2-10 Error Codes
) .
Pressing the left or right ar-
row key will toggle the dis-
play between the error mes-
sage and the corresponding
error code.
To perform another opera-
tion, or to abort the Step
Write operation, press the
RESET key. The display will
return to the reset status. In
this example, the display
indicates the reset status .
Another operation can now
be performed.
Section 3-2
63