Installing Drive Enclosures; Installation Rules For Drive Enclosures; Installable Drive Enclosures; Drive Enclosure Handling Instructions - Fujitsu ETERNUS DX60 S2 User Manual

Chapter 5 Installing Optional Products

5.2 Installing Drive Enclosures

5.2 Installing Drive Enclosures
Optional drive enclosures can be installed while the ETERNUS DX Disk storage system is run-
ning without affecting the system.
This section explains how to install optional drive enclosures.
5.2.1

Installation Rules for Drive Enclosures

Only one drive enclosure can be connected to a 3.5" type controller enclosure.
Drive enclosures cannot be connected to 2.5" type controller enclosures.
5.2.2

Installable Drive Enclosures

For installable drive enclosures, refer to "Product List".
5.2.3

Drive Enclosure Handling Instructions

■
About condensation
■
About static electricity
ETERNUS DX60 S2 Disk storage system User's Guide -Operation-
Do
CAUTION
• When moving a drive enclosure from a cold place, such as an un-
conditioned store house in winter, to a warmer place such as an air-
conditioned room, the severe temperature change may result in
condensation forming.
To avoid this, allow the packed drive enclosures sufficient time in the
warmer place (one hour for each 15°C of temperature difference) to
adapt to the new temperature.
Do
CAUTION
• When handling drive enclosures, make sure to wear a wrist strap or
touch a metal part to discharge the human body's natural static
electricity. Failure to discharge static electricity may cause device
failure.
Copyright 2013 FUJITSU LIMITED
63
P3AM-5512-05ENZ0