Fujitsu ETERNUS DX60 S2 User Manual page 60

Chapter 5 Installing Optional Products
5.1 Installing Disks
4-3
4-4
5
6
7
8
■
3.5" disks
Procedure
1
2
3
ETERNUS DX60 S2 Disk storage system User's Guide -Operation-
Swing the lock lever in the direction of the arrow, until the lock clicks shut.
Lock lever
Check that the newly installed disk's DISK READY LED lights up green after
approximately 30 seconds.
Repeat Step 3 and Step 4
If a wrist strap is used, remove the wrist strap.
On the Storage System Status screen of ETERNUS Web GUI, check that the
added disks have been recognized.
Set up RAID groups, volumes, hot spares, and Host Affinity settings on the new
disks, as required.
Check that all components of the ETERNUS DX Disk storage system are in
normal status, using the Storage System Status screen of ETERNUS Web GUI.
Remove the front cover.
For details on how to attach the front cover, refer to
Cover" (page 37).
Wear a wrist strap or touch a metal part to discharge the human body's natural
static electricity.
Copyright 2013 FUJITSU LIMITED
for each additional disk.
"2.3 Attaching and Removing the Front
60
End of procedure
P3AM-5512-05ENZ0