Informational Messages; A.2.4 Informational Messages - Fujitsu ETERNUS DX60 S2 User Manual

Appendix A Event Notification Message List
A.2 Message List
A.2.4

Informational Messages

This section describes the messages that are sent when the severity is Information.
■
Informational message list
●
When the event type is "I"
The following messages are sent when an information-level event occurs:
Event type
and event
I 00000001
I 00000002
I 00000011
I 00000011
ETERNUS DX60 S2 Disk storage system User's Guide -Operation-
SNMP
Trap
Trap
code
No.
9 Power on completed ($a)
Detail information is not displayed.
The device is powered ON.
$a: VxxLxx-xxxx (Firmware version)
9 Controller firmware updated ($a)
Detail information is not displayed.
Controller firmware version is updated.
$a: VxxLxx-xxxx (Firmware version)
9 Snap Data Pool (SDP) capacity reached $a%. (Policy Level1:
Threshold $b%)
Detail information is not displayed.
Snap Data Pool (unencrypted) usage rate exceeds the threshold
(Level1) $a% and reaches $b%.
$a: Usage rate of Snap Data Pool
$b: Threshold of Snap Data Pool
9 Snap Data Pool (SDP) capacity of the encryption reached $a%. (Policy
Level1: Threshold $b%)
Detail information is not displayed.
Snap Data Pool (encrypted) usage rate exceeds the threshold (Level1)
$a% and reaches $b%.
$a: Usage rate of Snap Data Pool
$b: Threshold of Snap Data Pool
Copyright 2013 FUJITSU LIMITED
Upper: Message
Middle: Detail information
Lower: Description
109
Remarks
These messages
are notified when
"Power on
Completed" is
enabled for
Informational Level
in the event
notification setting.
These messages
are notified when
"Controller
Firmware update" is
enabled for
Informational Level
in the event
notification setting.
These messages
are notified when
"Informational
message defined by
SDP policy" is
enabled for
Informational Level
in the event
notification setting.
P3AM-5512-05ENZ0