Fujitsu ETERNUS DX60 S2 User Manual page 40

Chapter 2 Standard Operations
2.4 Turning On and Off the AUTO POWER Switch
Procedure
1
2
3
ETERNUS DX60 S2 Disk storage system User's Guide -Operation-
Remove the flange cover from the 2.5" type controller enclosure.
Remove the front cover from the 3.5" type controller enclosure.
For details on how to remove the flange cover, refer to
Flange Cover" (page 35).
For details on how to remove the front cover, refer to
Front Cover" (page 37).
Turn the AUTO POWER switch of the controller enclosure to "ON".
Push up the AUTO POWER switch to the "ON" side using the pin that is provided with the
ETERNUS DX Disk storage system.
Pin
• The AUTO POWER switch of the drive enclosure is turned to
IMPORTANT
"OFF" as the factory setting, and should not be turned to "ON".
• If AC power is being supplied, turning the AUTO POWER switch
of the controller enclosure to "ON" will cause the ETERNUS DX
Disk storage system to turn on.
• If the AUTO POWER switch of the controller enclosure is turned
to "ON", connecting the power cord to the outlet will cause the
ETERNUS DX Disk storage system to turn on.
Re-attach the flange cover to the 2.5" type controller enclosure.
Re-attach the front cover to the 3.5" type controller enclosure.
For details on how to attach the flange cover, refer to
Flange Cover" (page 35).
For details on how to attach the front cover, refer to
Cover" (page 37).
Copyright 2013 FUJITSU LIMITED
"2.2 Attaching and Removing the
"2.3 Attaching and Removing the
AUTO POWER
switch
"2.2 Attaching and Removing the
"2.3 Attaching and Removing the Front
40
End of procedure
P3AM-5512-05ENZ0