Test Messages; Sense Codes; A.2.5 Test Messages; A.2.6 Sense Codes - Fujitsu ETERNUS DX60 S2 User Manual

Appendix A Event Notification Message List
A.2 Message List
A.2.5

Test Messages

The messages that are sent when the test notification of an event is performed in ETERNUS
Web GUI or ETERNUS CLI are described below.
■
Send Test E-Mail
The message is notified when the test notification of e-mail is performed in ETERNUS Web GUI
or ETERNUS CLI.
Event type and event code
T FFFFFFFF
■
Test Trap transmission
The message is notified when the test notification of the SNMP Trap is performed in ETERNUS
Web GUI or ETERNUS CLI.
Trap No.
2
A.2.6

Sense Codes

This section describes the sense codes that are notified to the server.
Sense code
SK
02
04
04
04
04
04
ETERNUS DX60 S2 Disk storage system User's Guide -Operation-
Test E-mail Message
TrapItemId
0x80000000 SNMP Trap Test
The Trap No. and ItemId in the test Trap are the same as the notification
that is sent when the disk in Slot#0 of DE#00 is in Fault status. A disk is not
actually disconnected when a test Trap is notified.
ASC ASCQ
04 00 The device is in Not Ready status.
F1 01 CM is disconnected.
F1 1A SFP is disconnected.
F1 80 3.5 inch Disk is disconnected.
F1 81 2.5 inch Disk is disconnected.
F1 88 Disk is disconnected because an error occurred during
the Write check of the disk patrol.
Copyright 2013 FUJITSU LIMITED
Message
TrapMessage
Description
118
Remarks
This sense code is notified when the
relevant event occurs.
These sense codes are notified when
"Module was broken" is enabled for
Error Severity Level in the event
notification setting.
They are not notified during
maintenance operations.
These sense codes are notified when
"Disk was broken" is enabled for Error
Severity Level in the event notification
setting.
They are not notified during
maintenance operations.
These sense codes are notified when
the relevant event is detected during
Disk Patrol.
P3AM-5512-05ENZ0