Fujitsu ETERNUS DX60 S2 User Manual page 67

Chapter 5 Installing Optional Products
5.2 Installing Drive Enclosures
3
4
ETERNUS DX60 S2 Disk storage system User's Guide -Operation-
(2)
Attach the rack rails to the rack.
•
•
Rack rail (for left side)
Washers
M5 screws
(Front rack pillars)
M5 screws
The M5 screw positions for the rack rails are determined relative to the drive enclosure
base line.
The M5 screws should be inserted in the 1st and 3rd holes above the base line.
[Left]
3rd position
2U
(M5 screws)
1st position
(M5 screws)
drive enclosure
(3)
Tighten the M4 screws of the rack rails that were slightly unscrewed in
Remove the front cover.
For details on how to attach the front cover, refer to
Cover" (page 37).
Install the drive enclosure in the rack.
CAUTION
• When installing or removing the drive enclosure to or from the
rack, make sure to have the right and left sides and the bottom
of the drive enclosure by two or more people. Failure to do so
may cause injury.
Copyright 2013 FUJITSU LIMITED
If the rack pillars have square (approx. 9mm) holes, screw
holders will need to be used when attaching the rack rails.
Make sure to attach the rack rails and rack pillars so that they
fit exactly together without any space between them.
Rack rail (for right side)
Washers
[Right]
3rd position
Drive enclosure
(M5 screws)
1st position
(M5 screws)
Base line of
Rack rails
"2.3 Attaching and Removing the Front
Do
67
Washers
M5 screws
M5 screws
(Rear rack pillars)
Washers
Step
P3AM-5512-05ENZ0
(1).