Fujitsu ETERNUS DX60 S2 User Manual page 62

Chapter 5 Installing Optional Products
5.1 Installing Disks
5-3
5-4
6
7
8
9
10
ETERNUS DX60 S2 Disk storage system User's Guide -Operation-
Swing the lock lever in the direction of the arrow, until the lock clicks shut.
Make sure that the lock lever hooks have engaged the slot
IMPORTANT
protrusions.
Check that the newly installed disk's DISK READY/FAULT LED lights up green after
approximately 30 seconds.
Repeat Step 4 and Step 5
Remove the wrist strap.
Remove the front cover.
For details on how to attach the front cover, refer to
Front Cover" (page 37).
On the Storage System Status screen of ETERNUS Web GUI, check that the
added disks have been recognized.
Set up RAID groups, volumes, hot spares, and Host Affinity settings on the new
disks, as required.
Copyright 2013 FUJITSU LIMITED
Lock lever
Lock lever hooks Lock lever hooks
have engaged have not engaged
Slot
protrusion
Hook
for each additional disk.
"2.3 Attaching and Removing the
62
Slot
protrusion
Hook
End of procedure
P3AM-5512-05ENZ0