Optical Drive Troubleshooting; Procedure 1 Diagnostic Test Program Execution Check; Procedure 2 Connector Check And Replacement Check; Procedure 1 - Toshiba Tecra M2V Maintenance Manual

2 Troubleshooting Procedures
2.9

Optical drive Troubleshooting

This section describes how to determine if the optical drive (DVD-ROM, CD-RW/DVD-
ROM, DVD±R/±RW, DVD Multi drive or DVD Super Multi drive) in the Slim Select Bay is
functioning properly. Perform the steps below starting with Procedure 1 and continue with
the other procedures as required.
Procedure 1: Diagnostic Test Program Execution Check
Procedure 2: Connector Check and Replacement Check

Procedure 1

Diagnostic Test Program Execution Check
The CD-ROM/DVD-ROM test program is stored in the Diagnostics Disk.
For the test, prepare test Media.
Then insert the Diagnostics Disk in the computer's floppy disk drive, turn on the computer
and run the test. Refer to Chapter 3, Tests and Diagnostics, for more information about the
diagnostics test procedures.
If any errors occur while executing the CD-ROM/DVD-ROM test, go to Procedure 2.
2-42
2.9 Optical drive Troubleshooting
TECRA M2V Maintenance Manual (960-476)