Toshiba Tecra M2V Maintenance Manual page 221

4.7 Slim select bay module
Installing the Slim select bay module
To install the slim select bay module, follow the steps below and refer to figures 4-9 and 4-
10.
1. Seat the plastic frame on the side of the slim select bay module, and secure it with
the following screws.
• M2×3S
2. Install the connector and plastic brace and secure them with the following screws.
• M2×8S
3. Insert the slim select bay module into the computer to connect it to the connector on
the system board.
4. Remove the following screw from the screw hole. Then secure the latch with the
removed screw. (The slim select bay is locked.)
• M2.5×4B FLAT HEAD screw
TECRA M2V Maintenance Manual (960-476)
S-FLAT HEAD screw
BIND screw
4 Replacement Procedures
×5
×2
×1
4-21