Procedure 2 Printer Port Led Check On Boot Mode - Toshiba Tecra M2V Maintenance Manual

2.4 System Board Troubleshooting
Procedure 2 Printer Port LED Check on Boot Mode
The printer port LED displays the IRT (Initial Reliability Test) status and test status by
turning lights on and off as an eight-digit binary value for boot mode. Figure 2-2 shows the
printer port LED.
To use the printer port LED, follow the steps below:
1. Plug the printer port LED into the parallel port.
2. Read the LED status from left to right as you are facing the back of the computer.
3. Convert the status from binary to hexadecimal notation.
4. If the final LED status is FFh (normal status), go to Procedure 3.
5. If the final LED status matches any of the test status values in Table 2-5, go to
Procedure 4.
NOTE: If an error is detected by the IRT test, the printer port LED displays an error
code. For example, when the printer port LED displays B0 and halts, it indicates
an error has been detected during the Flash ROM check.
TECRA M2V Maintenance Manual (960-476)
Figure 2-2 Printer port LED
2 Troubleshooting Procedures
2-19