4 Replacement Procedures
4.2
Battery pack
Removing the Battery pack
To remove the battery pack, follow the steps below and refer to figure 4-1.
CAUTION: When handling battery packs, be careful not to short circuit the terminals.
Also do not drop, hit or apply impact; do not scratch, break, twist or bend
the battery pack.
1. Turn off the power of the computer.
2. Disconnect the AC cable and other external devices from the computer.
3. Turn the computer face down.
4. Release the battery lock. Lift up the battery pack while sliding the battery latch.
NOTE: For environmental reasons, do not throw away a spent battery pack. Collect the
spent battery packs.
Battery latch
4-8
Battery lock
Figure 4-1 Removing the battery pack
Battery pack
TECRA M2V Maintenance Manual (960-476)
4.2 Battery pack