Toshiba Tecra M2V Maintenance Manual page 107

2.13 Sound Troubleshooting
Procedure 2 Connector Check
The sound function-wiring diagram is shown below:
Any of the connections may be disconnected. Disassemble the computer following the steps
described in Chapter 4, Replacement Procedures and perform the following checks:
1. If the stereo speakers do not work correctly, perform Check 1.
2. If the headphone does not work correctly, perform Check 2.
3. If the microphones do not work correctly, perform Check 3.
Check 1 If the stereo speakers do not work properly, the speaker cable may be
disconnected. Make sure the speaker cable is firmly connected to PJ3202 on the
sound board. If the stereo speakers are still not functioning properly, go to Check
4.
Check 2 If the headphone does not work properly, the headphone cable may be
disconnected. Make sure the headphone cable is firmly connected to PJ6000 on
the sound board. If the sound function still does not work properly, go to Check 4.
Check 3 If the external microphones do not work properly, the external microphone cable
may be disconnected. Make sure the external microphone cable is firmly
connected to PJ6002 on the system board. If the microphones are still not
functioning properly, go to Check 4.
Check 4 Make sure the sound board flexible cable is firmly connected to PJ9510 on the
sound board and to PJ9500 on the system board.
If the sound board flexible cable is disconnected, connect it firmly and perform
Procedure 1. If the sound function is still not functioning properly, go to
procedure 3.
TECRA M2V Maintenance Manual (960-476)
2 Troubleshooting Procedures
2-51